VOYAGER XII - Center Stand with COBRA pipes

Second Stage Stands Rubber hits COBRA Pipe (GOOD!).  Forward part of Bike to LEFT.

First Stage Stand METAL hits COBRA Pipe (BAD!). Forward part of bike to LEFT.

Stand feet are FLOATING because Rubber on the FIRST stage bar has nowhere to rest.  I am going to position high density foam on each side of the swing arm, so that the First Stage round bar does not rest/bounce on COBRA Pipe.

I found the High Density Styrofoam to be a temperature resistant cushion to put on the swing arm, so that the center stand feet (one on each side) keeps the 'first' stage round bar from contacting the Cobra pipe.  This piece of foam has about 3,000 miles of contact

 Forward part of bike to right.

California Emissions Carbon Canister

'Pillow' of High Density Styrofoam for California Emissions Carbon Canister that sits in front of Gas Tank and behind the Fuel Filter.  Used this white Styrofoam 'pillow' as the rubber strap is broken and after two hours of trying to put on the strap - gave up!  Use either contact cement or Gorilla Glue.

Copyright © 1999 - 2012 Just for You.  All trademarks used are
trademarks of Just for You. 

    Contact  for information about this Webpage.